资源列表
GIVEIO.rar
- 三星ARM的JTAG 并口设置,将PC的并口设置成GIVEIO的串行口.,Configuare PC s parallel port to Serial Port for using JTAG probe.
3(FDKG)
- 分段开关-通过按键实现端口的变化。达到分段功能。-Disconnect switches- buttons achieved through changes in the mouth
C51-Calculator
- 基于8051单片机的计算器设计、proteus仿真软件、在LCD屏幕显示、按键控制-8051 based on the calculator design, proteus simulation software, the LCD screen display, control buttons
zhengxian-output
- 利用单片机实现正弦波的输出，程序代码简历-MCU sine wave output, the program code resume
CH451
- CH5451驱动键盘的程序，使用atmega16作为控制器，用lcd12864做显示。-CH5451 keyboard driver program, use atmega16 as the controller to do with lcd12864 display.
Shooter-game
- 本工程文件是基于keil和proteus的射击游戏的仿真，代码实现射击游戏的基本功能，并通过proteus验证成功。-This project file is shooting simulation game based on the proteus and keil code to achieve the basic functions of shooting game, and verified by proteus success.
90495_can_uart_async-v14_1
- 富士通90945系列 CAN收发程序 可以跑起来,内容比较简单,但是实现了中断收发,可设置.-Fujitsu 90945 Series CAN transceiver programs can run up, the contents of relatively simple, but it achieved a break transceiver, can be set.
Atmega128_Matrix_Converter
- BASIC program in atmega128 to control a 3ph matrix converter
shejixunlianyouxi
- 单片机C语言程序设计——基于8051+Proteus仿真- 射击训练游戏-C language programming – based on single-chip-8051+Proteus simulation-shooting games
PWM-output-experiment
- 基于低功耗MSP430单片机的PWM输出实验-Based on low-power MSP430 MCU PWM output experiment
can_show_remote
- CAN总线上挂接两个节点，当其中一个节点（节点1）的按键按下时，除了自身的数码管1、2显示加一，还向节点2发送一个远程帧；节点2接收到远程帧后想总线发送一个数据帧，如果节点2的按键被按下时，除了自身的数码管1、2显示加一，还会向总线发送数据帧，使得节点2的数码管3、4显示与其保持一致。-CAN bus articulated two nodes, when one node (Node 1) of the button is depressed, in addition to its own d
at24c64
- AT24C64串行读写程序 用普通I/O口进行总线模拟-AT24C64 serial reading and writing program with the ordinary I/O port for bus simulation