资源列表
fenlipu
- 本程序是基于分离谱算法的最小值选中次数加权算法的MATLAB源代码,可以对一维信号先进行谱分离,然后再在最小值的基础上对信号进行重建.-This procedure is based on the sub-out algorithm to select the minimum number of weighted algorithm MATLAB source code, can be conducted one-dimensional spectral signal separation, t
filter0
- Useing the MATLAB command remez to obtain a low pass filter z(n) with a cutof frequency of 40 Hz at a sample rate of 1000 Hz.
work
- 信号功率谱分析，有各种方法，在此一一编写，方法一-Signal power spectrum analysis, there are various methods, in which 11 the preparation of, method 1
mulGXF
- 本代码为割线法求解非线性方程组。其调用格式为[r,m]=mulGXF1(F,x0,x1,eps) 其中，F:非线性方程组；x0初始解；x1：初始解；eps：解的精度；m：迭代步数。-The code for the secant method for solving nonlinear equations. Its call format [r, m] = mulGXF1 (F, x0, x1, eps) where, F: non-linear equations x0 initial s
2psk
- 基于2psk调制下的网络编码性能分析。使用matlab平台开发。针对网络编码的公式进行画图分析。-On 2psk modulation of network coding performance analysis. Use matlab platform. The formula for drawing network coding analysis.
Datee
- 对于任意三个整数，判断其是否为一个合法的日期值。给定一个日期值，计算若干天后的日期值，-For any three integers, determine whether it was a valid date value. Given a date and calculate the value of a number of days of the date,
hc837
- 双线性变换法由切贝雪夫II原型变为数字滤波器-Bilinear transform into a prototype by the Chebychev digital filter II
CRC
- CRC check for WLN frame word！
jade
- 基于四阶累积量的联合对角化，其中给出两种四阶累积量计算方法，方便理解。这个算法还是比较难的，可以参看下独立分量分析中的jade算法-Fourth-order cumulant-based joint diagonalization, which gives two fourth-order cumulant method, easy to understand. This algorithm is quite difficult, you can see under the jade indep
piddata
- 包含pid控制器的一些程序，能够生成有故障或无故障数据，为一些相应matlab仿真提供数据-we can use it to produce pid-data
2_OFDM_AWGN_SIM
- OFDM At AWGN CHANEL
tri
- this file is to solve the problem of the tridiagonal and banded systems