资源列表
Electronicorgan
- 利用VHDL编写的电子琴发生器，以简单的演奏电路论文-Electronic organ prepared using VHDL generator to perform a simple circuit Papers
Kdtree
- 本程序实现了kdtree算法，这是一个经典的算法，可以作为颅面重构的辅助程序-Realized by the kdtree algorithm, which is a classical algorithm can be used as a secondary craniofacial reconstruction program
cabquan
- 庞加莱模拟分岔图的matlab代码，仅供参考-poincare chaos
rsa
- RSA加密 为netbox设计的，可以设置填充模式-RAS CORD CODEING BY NETBOX
FPGA_Clk
- 基于Cyclone EP1C6240C8 FPGA的时钟产生模块。主要用于为FPGA系统其他模块产生时钟信号。采用verilog编写。 使用计时器的方式产生时钟波形。 提供对于FPGA时钟的偶数分频、奇数分频、始终脉冲宽度等功能。-Based on Cyclone EP1C6240C8 FPGA' s clock generator module. Is mainly used for the FPGA system clock signal generated in other
mimemail_python
- python写的 发送mime邮件的模块，很好用-written in python send mime mail module, a very good use
smartcar_monitor
- Labview串口通信界面，并且可以保存接收回来的数据，数据格式为.dat，可用Excel打开-Labview serial communication interface, and can save the data to receive back the data format. Dat, can be used to open Excel
CommAssistant_exam
- USB转串口固件编程程序代码，芯片为68013-USB CommAssistan
functiongmodify
- 应用matlab简单实现镜头畸变的校正，可用于cmos ccd-Application of a simple implementation of matlab lens distortion correction, can be used for cmos ccd
WebBrowserUI
- 经过重装并扩展后的WebBrowser控件-After reloading, and the extended WebBrowser control
cx
- AVR单片机ATmega16控制步进电机程序，发送字符A\B\C\D\E可以控制步进电机的正传、反转、加速、减速、停止-AVR Microcontroller ATmega16 stepper motor control program, sending characters A \ B \ C \ D \ E can control the stepper motor Cinema, reversal, acceleration, deceleration, and stop
qtgpsc
- 使用Qt编写的GPS程序,在Ubuntu 10.10下构建的QT ARM开发环境-The GPS program by Qt in Ubuntu 10.10