资源列表
BOOTLoader
- AVR单片机 可支持485或232接口。变异软件ICCAVR，上位机软件应用超级终端或avrubd等，Xmodem，9600,8,1，n(AVR single chip can support 485 or 232 interfaces. Mutation software ICCAVR, upper computer software application super terminal or avrubd, Xmodem, 9600,8,1, n)
HTS221
- 温湿度传感器HTS221驱动，stm32环境，亲测可用(Temperature and humidity sensor HTS221 drive, STM32 environment, pro test available)
1KHZ
- 简易1kHz至1MHz方波信号频率计 配置LCD1602数据,循环显示，循环变动频率(A simple 1kHz to 1MHz square wave signal frequency meter)
PT2313
- pt2313 特点： ?1、支持3个音源通道输入切换(可以做音频混合)，四组音频输出通道(前、后、左、右) ?2、支持调节高、低音音效、音量、前后左右增益与均衡控制(1, support 3 channel audio input switching (can do audio mixing, four audio output channels) (before and after, left and right) 2, support regulating high, bass sou
数码管
- 数码管显示，可以在Keil uVision中进行调试和修改(The digital tube shows that it can be debugged and modified in Keil uVision)
Calculator
- 这是一个简单的51单片机的计算器程序，大家可参看里面的算法。(This is a simple calculator program for 8051)
PIC16F877A_93C46
- PIC16F877A读写AT93C46,代码已经验证过的,可以运行(PIC16F877A read and write AT93C46, the code has been verified, can run)
FreqSweep
- 此程序用于arduino板（nano，其他可适当修改引脚），MCU采集信号发生器的波形，然后再输出同等频率的互补方波，主要用于驱动全桥或半桥逆变电路，可作为电力电子电路驱动信号扫频。 信号发生器采集引脚：D4 输出方波引脚：D9和D10(This program is used for Arduino board(nano,also can be modified for other types). MCU collect waveform from signal generator,th
source
- 红外线遥控器的接收程序，可以测出每个遥控器按键的键码值，并能过LCD1602显示出来。(nfrared remote controller receiving program, can measure the key code value of each remote control, and can be displayed over LCD1602.)
app [2]
- Testversion of an Application111
set_ad9522
- 通过C语言配置ad9522寄存器，在DSP上可直接运行，已测试，想学习ad9522的是很好的资料。(Config ad9522 registers by C/C++ language.Running on TI s DSP testing procedures, can be run directly, want to learn ad9522 is a good information.)
IR
- 红外遥控发固定码值程序，可以循环发送码值(IR send and can send always)