资源列表
firmatlab
- fir在dspbuilder下产生VHDL源码及其测试激励文件时的matlab模型,在modelsim下仿真通过-fir in dspbuilder VHDL source code under test and document the incentive mat lab model, the simulation under through modelsim
ddsmatlab
- dds在dspbuilder下产生VHDL源码及其测试激励文件的matlab模型,在modelsim下仿真通过-dds dspbuilder under the VHDL source code and test incentives document matl ab model, the simulation under through modelsim
sinmdlmatlab
- 正弦波在dspbuilder下产生VHDL源码及其测试激励文件的matlab模型,在modelsim下仿真通过-sine wave in dspbuilder under VHDL source code and test incentives document matl ab model, the simulation under through modelsim
xapp290
- 从Xilinx网站上下的，学习FPGA部分动态重配置很好的例子。-from across the Xilinx website, learning some FPGA dynamic reconfigurable good example.
verilog100
- 有很多例子及测试代码，对初学者很有帮助，很容易上手-a lot of examples and test code, useful for beginners, it is easy to get started
FPGAUART
- 一个基于FPGA的串口程序,已经经过验证,对用FPGA做串口的朋友提供参考和借鉴!-an FPGA-based serial procedures have proven, right Serial do with FPGA reference for a friend and borrow!
DE2_NIOS_DEVICE_LED
- 这个源代码可以把DE2的板子作为一个USB设备使用，以便用PC软件去控制DE2-the source code can Dictyophora the board as a USB device use, to use PC software to control DE2
I2CSlave
- Verilog HDL实现的I2C Slave模拟-achieve the Verilog HDL simulation I2C Slave
lru_new
- 采用LRU替换算法。这种算法选择最久没有被访问的块作为被替换的块。 为了实现LRU算法，要在块表中为每一块设置一个计数器（cnt0，cnt1，cnt2，cnt3，）。计数器的长度为2位。-using LRU replacement algorithm. This algorithm to choose the most long visit is not being replaced as a block by block. To achieve LRU algorithm, in bloc
I2C_1.1
- Simple I2C controller -- 1) No multimaster -- 2) No slave mode -- 3) No fifo s -- -- notes: -- Every command is acknowledged. Do not set a new command before previous is acknowledged. -- Dout is available 1 clock cycle later as cmd_a
tst_ds1621
- -- State machine for reading data from Dallas 1621 -- -- Testsystem for i2c controller--- State machine for reading data from Dall as 1621 -- -- Testsystem for i2c controller
wishbone_i2c_master
- -- WISHBONE revB2 compiant I2C master core -- -- author: Richard Herveille -- rev. 0.1 based on simple_i2c -- rev. 0.2 april 27th 2001, fixed incomplete sensitivity list on assign_dato process (thanks to Matt Oseman) -- rev. 0.3 may 4th 200