资源列表
JT
- AT89C51 1602Lcd 示例程序-AT89C51 1602Lcd sample program
dff
- 用VHDL语言编写的带进位、置位、复位的D触发器，异步清零D触发器，同步清零D触发器-library ieee use ieee.std_logic_1164.all use ieee.std_logic_unsigned.all entity exp7_10 is port( clk: in std_logic d: in std_logic clr: in std_logic en,s:in std_logic q: o
SOU
- 这是用C写的正弦函数定点数据生成代码，内容是生成verilog中RAM或者ROM和Matlab处理时的所用的数据。-It is written with C fixed-point data generate code sine function, the content is generated verilog RAM or ROM, and Matlab in the processing of the data used.
half_add
- 半加器，可移植性很强，只需改变内部的数字，即可得到任意的加法器！-The counter, portability is very strong, only need to a change in the inside of the digital can get any counter!!!!!
STC12C5A60S2_UART2
- STC12C5A60S2的第二串口程序，本人亲自写的，绝对好用。-Second STC12C5A60S2 serial procedures , personally written , absolutely easy to use .
shift-register
- 一个8位的左右移位寄存器电路，输入为时钟信号CLK，方向控制信号D， 输出信号为每个寄存器的状态。 -An 8-bit left and right shift register circuit, the input of the clock signal CLK, the direction control signal D, the output signal of the status of each register.
counter
- 在FPGA 设计中，计数器可以用来对信号的变化情况进行计数，是经常使用的功能块。 这里设计的是一个2 位宽计数器，可以从00 计数到11，计数原则是在时钟信号的控制下，每个时钟周期计数一次。计数器属于时序逻辑电路。-In the FPGA, the counter can be used to count the changes in the signal, the function block is often used. Here design is a two-bit wide,
APB_slave
- APB slave template for AMBA bus written in Verilog
stm485
- 3485的c语言代码，能够实现485的接受和发送,可以用于stm8处理器上。-3485 c language code, to achieve acceptable and send 485 can be used on stm8 processor.
Array-multiplier
- Array muiltiplier verilog code.. 4 bit two inputs with 8 bit outputs
my-TextStepMotor
- 本程序主要是通过单片机控制的步进电机的控制，通过本程序读者可以更好的理解步进电机。-This procedure is mainly controlled by the microprocessor controlled stepper motor, through this program the reader a better understanding of the stepper motor.
rom
- 生成rom的代码-The code generated rom.。。。。。。。。。。。