资源列表
uboot_s3c2443
- u-boot 在s3c2443上的移植,讲解在移植过程中的一些方法和需要注意的地方。
clock
- 单片机的开发与应用-数字时钟的实现（C语言编程）-Development and application of SCM- Implementation of digital clock (C programming)
cm5321
- PoC for Omnikey Cardman 5321 communication using libusb, very dirty example
led0-99-tmr0-int
- 自己编写的一个PIC程序，可实现0—99记数并通过数码管显示，应用了TMR0中断。-themselves prepared a PIC procedure can achieve 0-99 counting and through digital control, Application of TMR0 interruption.
C51UART16X56LED
- 用51单片机串口及595制作16X56LED显示屏(土产)-With 51 and 595 produced single-chip serial 16X56LED display (native)
YCbCr2RGB
- 将图像数据Ycbcr格式转换为rgb格式，方便显示器显示。-Converting the image data Ycbcr format to RGB format , facilitating the monitor display.
fft
- c语言编写的FFT变换，程序简易调试通过，能够运行。-c language FFT, simple debugging program to run.
uart
- msp430 单片机的 串口 ad e2prom AD5933芯片的使用串口串口串口串口-msp430 单片机的 串口 ad e2prom AD5933芯片的使用串口串口串口串口
X1226
- X1226模拟I2C程序，此程序为51环境下，用在其它芯片上需要修正时序-X1226 simulation I2C procedures, the procedures for the next 51 environment, with the need to fix the timing on other chips
Interfacing-with-a-Philips-PCF8574-8-bit-IO
- The PCF8574 uses the Philips I2C 2-wire protocol and provides eight I/O channels per device. Eight such devices may be cascaded by setting the A2, A1 and A0 leads to uniquely identify each device. In addition, up to eight PCF8574A devices may
DDBHB
- 一个测试多节保护板板程序，可用来测试多节保护板的充放电-A multi-section protection plate board test procedures can be used to test the multi-section protective plate discharge
move
- 智能车接收上位机发送的指令，完成相应移动，包含三步，旋转、前进/后退、再旋转- U667A u80FD u8F66 u63A5 u6536 u4E0A u4F4D u673A u53D1 u9001 u7684 u6307 u4EE4 uFF0C u5B8C u6210 u76F8 u5E94 u79FB u52A8 uFF0C u5305 u542B u4E09 u6B65 uFF0C u65CB u8F6C u3001 u524D