资源列表
DS18B20gai
- 实现对DS18B20的读取,注意：单总线协议对延时要求比较严格，此程序中采用的是11.0592M的晶振，如果使用其他的晶振请跟据DS18B20的资料修改延时参数 -DS18B20 achieve the right read, attention : single bus protocol to delay more stringent requirements, This procedure is used in the M 11.0592 Crystal Oscillator, If y
eeprom
- eeprom在51中的读写c代码，已测试通过，可以直接下载使用-eeprom read and write in 51 of the c code, have been tested, you can directly download
ask100
- 时钟同步模块：通过时钟同步模块，将模拟前端提取的时钟信号和数据进行同步，使得数字后端可以正确读取数据。-Clock synchronization module: The clock synchronization module, the analog front-end of the clock signal extraction and data synchronization, making the number of back-end data can be read correctly
Queuing
- 一种高效的排序VHDL程序，本程序节省资源，最高效的发挥FPGA的时序能力。-a kind of Queuing VHDL Program
rxremote
- this program is very useful for many people
state_machine
- 状态机控制步进电机 配套开发板型号:A-C8V4-Stepper motor control state machine model supporting the development board: A-C8V4
005-dianliangshumaguan
- 单片机数码管程序，对应灯的编号，希望对你有帮助-SCM digital tube program, corresponding to the light of the Numbers, and I hope to help you
prbs
- 伪二进制随机码的产生，在fpga上已经验证-Pseudo-random binary code generation
fifo
- 同步fifo，使用ISE13.4 V5器件 速度550MHz-Synchronous fifo, use ISE13.4 V5 device speed 550MHz
bujin3
- 步进电机源码程序，具有暂停、加减速、正反转等功能-Stepper motor source program, with a pause, acceleration and deceleration, reversing etc.
DianZiQin
- 宏晶STC51单片机STC89C54RD+电子琴程序演示-Keyboard Program
L3G4200D_SPI_FOR_Arduino
- 本程序基于Arduino UNO开发，代码通过SPI接口读取L3G4200D陀螺仪的Y轴角速率-This program is based on Arduino UNO. This program read Y-axis rate L3G4200D Gyro through SPI interface.