资源列表
LED
- at89c51 的跑马灯程序. 把LED灯连接到端口0然后用烧录到单片机就行了.-This is an AT89C51 LED chaser program. Connect LEDs to port 1 and then use KEIL to compile the leds1.C into a .hex file then download t to your microcontroller.
12864_9(8080)
- 单片机实现128*64液晶显示图案，以测试成功-SCM 128* 64 LCD display patterns to test the success of
timer0demo
- 每50ms定时器0发生一次溢出中断，中断发生五次之后改变8个LED的状态。-Occur once every 50ms Timer 0 overflow interrupt, the interrupt occurs after the change in eight five LED status.
Trafficlights
- 十字路*通指示灯，绿灯25秒，红灯30秒，黄灯5秒，允许各路口右转-Intersection traffic light, green light 25 seconds, 30 seconds, red light, yellow light 5 seconds, allowing the intersection to turn right
KD2051
- 单片机知识！，简单的单片机程序，供大家参考-SCM knowledge! Simple microcontroller program, for your reference! ! !
outcount
- 实现对外界中断计数并用四位数码管显示，数码管使用刷屏实现-To achieve the four external interrupt count and use digital display, digital control to achieve use of scraper
infrared-detection-
- STC单片机实现人体红外 里面还有1138的一些例程 有需要的可以-STC MCU to achieve infrared detection
ttt051
- 基于CC2430的ZiBEE通信协议，实现无线智能家电控制-CC2430' s ZiBEE based communication protocol for wireless intelligent appliance control
123
- 这是我自己编写的程序，主要写的是串口程序-This is my own written procedures, mainly written by the serial program
1
- 利用Atmega16，选用内部2.56V做参考，AD采集成功，可此采集不超过2.56V的电压。-Based on Atmega16 use, selection of the internal 2.56V reference, the AD acquisition, but this collection does not exceed 2.56V voltage.
cewen
- DS18B20测温程序，可以显示-55~125之间的温度-DS18B20 temperature measurement program, you can display the temperature between-55 to 125
main
- protues仿真+c51+ds18b20+12864-protues simulation+c51+ds18b20+12864