资源列表
MSP430_LCD
- MSP430段码显示，C编写，经过MSP430FW427上调试过。可以参考学习这样的方法。-MSP430 of code, C, the upward after MSP430FW427 tried. Learning can refer to the method.
CalcCRC
- CalcCRC8 The CalcCRC8 is used to append an eight-bit CRC to the message. A successful CRC check results in returning a 0. Implementation: This CRC will be using the CRC-16/CITT protocol. A 16-bit wide non-reflected code that starts initially
boncewen
- 用于模拟磁流变液刚度和阻尼的boucewen模型-The magnetorheological fluid boucewen model
ser_test
- 用Moore状态机测试序列1110010-Test the series"1110010" in Moore FSM
step_motor
- AVR ATmega128 source code for controlling STEP motor. C source code for codevision avr.
button_led
- 这是用按键来控制与AVR单片机连接的led程序，可以根据按键的不同，led会做出不同的响应-Keys to control the LED program to connect with the AVR microcontroller, depending on the button, the LED will respond differently to
compass_interrupt
- 利用单片机制作电子罗盘的例程，采用分模块编写形式。-Microcontroller to produce the electronic compass routine, written as a module
STC89C51bujindianjiL297L298
- 51单片机通过L297和L298控制步进电机驱动程序-51 MCU through the control of L297 and L298 stepper motor driver
jkff.vhd.txt
- JK FLIT-FLOPbianyi jian dan li ti
51
- 这是一个51单片机控制步进电机的程序 与大家分享下-This is a 51 stepper motor control procedures to share with you
Led-for-lpc1114
- 这个程序是LPC1114上的指示灯程序，经过调试可以运行。-This program is the indicator lights on the LPC1114 program, after commissioning can run.