CDN加速镜像 | 设为首页 | 加入收藏夹
当前位置: 首页 源码下载 嵌入式/单片机编程

资源列表

« 1 2 ... .74 .75 .76 .77 .78 4079.80 .81 .82 .83 .84 ... 33646 »
  1. CoreUartTest

    2下载:
  2. Actel FPGA UART 串口通信模块,调用Actel CoreUART IP核实现。已在Microsemi Actel FPGA A3PE1500 硬件验证通过。-Actel FPGA UART serial communication module, call Actel CoreUART IP core implementation. Verified by Microsemi Actel FPGA A3PE1500 hardware.
  3. 所属分类:VHDL-FPGA-Verilog

    • 发布日期:2017-05-03
    • 文件大小:817.47kb
    • 提供者:
  1. VerilogUart

    0下载:
  2. UART 串口通信模块,Verilog 实现。已在Microsemi Actel FPGA A3PE1500 硬件验证通过。-UART serial communication module, Verilog implementation. Verified by Microsemi Actel FPGA A3PE1500 hardware.
  3. 所属分类:VHDL-FPGA-Verilog

    • 发布日期:2017-05-03
    • 文件大小:946.45kb
    • 提供者:
  1. hdlc

    2下载:
  2. hdlc协议的封装与解析,fsc校验,完整的例程代码-Decode and Encode an HDLC packet ,using FCS16 calculation
  3. 所属分类:Other Embeded program

    • 发布日期:2017-04-29
    • 文件大小:8.88kb
    • 提供者:林炜岚
  1. C8051F500aDS1302

    0下载:
  2. C8051F500单片机控制时钟控制器DS1302-C8051F500’s DS1302
  3. 所属分类:SCM

    • 发布日期:2017-04-13
    • 文件大小:1.51kb
    • 提供者:wyw
  1. GY-27-HMC5883-STC-IIC

    0下载:
  2. 基于51单片机使用HMC2883程序,可以实时测量角度值-Based on 51 MCU HMC2883 program, real time measurement of the angle value
  3. 所属分类:SCM

    • 发布日期:2017-04-14
    • 文件大小:2.93kb
    • 提供者:zhaoxiaojie
  1. nrf51_sdk_v5_2_0_39364-ver0.0-PAP017

    0下载:
  2. KEIL环境下编写的蓝牙无线串口收发程序,蓝牙芯片用的是nrf51-KEIL environment prepared under Bluetooth wireless serial transceiver procedures, using a Bluetooth chip nrf5188
  3. 所属分类:Other Embeded program

    • 发布日期:2017-06-13
    • 文件大小:20.05mb
    • 提供者:afati
  1. txmit

    0下载:
  2. uart设计,发送模块,无校验位。先输出一个低电平的起始位,然后从低到高输出8个数据位,接着是可选的奇偶校验位(这里没有),最后是高电平的停止位。-uart design, transmit module, no parity. First output of the start bit of a low level, and low to high output 8 data bits, then the optional parity bit (there is no), the last
  3. 所属分类:VHDL-FPGA-Verilog

    • 发布日期:2017-04-12
    • 文件大小:842byte
    • 提供者:Luke
  1. Example_28335_Flash

    0下载:
  2. 实现FLASH自由存储和读取,代码经过验证可以直接使用-Implement free FLASH storage and read the code after validation can be used directly
  3. 所属分类:DSP program

    • 发布日期:2017-04-29
    • 文件大小:222.67kb
    • 提供者:金铭
  1. INT_PRC

    0下载:
  2. 对于DSP28335 中断模块寄存器组标准的寄存器配置,使用时无需重复配置寄存器可以将中断函数写入中断向量表-Standard set of registers with DSP28335 interrupt module configuration, do not need to repeat the configuration register when using the interrupt function can be written to interrupt to scale
  3. 所属分类:DSP program

    • 发布日期:2017-05-03
    • 文件大小:569.07kb
    • 提供者:金铭
  1. ePWM_PRC

    0下载:
  2. 对于DSP28334 ePWM模块寄存器组标准的寄存器配置,可以根据需要任意改变占空比-Standard set of registers for DSP28334 ePWM module configuration, can arbitrarily change the duty ratio according to need
  3. 所属分类:DSP program

    • 发布日期:2017-04-29
    • 文件大小:286.36kb
    • 提供者:金铭
  1. GPIO_PRC

    0下载:
  2. DSP28335 GPIO端口标准寄存器组配置,可以根据需要自由改动GPIO的相应的配置-DSP28335GPIO port configuration register group, can according to need to freely change the corresponding GPIO configuration
  3. 所属分类:DSP program

    • 发布日期:2017-04-29
    • 文件大小:282.67kb
    • 提供者:金铭
  1. ADC_PRC

    0下载:
  2. DSP28335AD模块标准的寄存器配置,可以实现16通道的自由序列采集-DSP28335AD module standard register configuration, can achieve 16 free sequence acquisition channels
  3. 所属分类:DSP program

    • 发布日期:2017-04-29
    • 文件大小:344.91kb
    • 提供者:金铭
« 1 2 ... .74 .75 .76 .77 .78 4079.80 .81 .82 .83 .84 ... 33646 »
搜珍网 www.dssz.com

浏览历史记录

关闭