资源列表
20130710+10ms-TEST淄博vcb
- 可控被压整流，中断输出控制，键盘输入控制，温度控制(Controlled voltage rectification, interrupt output control, keyboard input control, temperature control)
TRAMS-arduino
- 3D打印TMC5130驱动程序，修正了原版的错程问题(TMC5130 river for 3d printer, debug missing step problem.)
函数资料
- 利用电磁感应控制轨道,轨道上有铝膜，传感器是线圈组成，线圈与轨道的电磁感应导向。(use of the electric to control the smart car)
stm32_w5500_loopback
- stm32上移植W5500库文件，已测试可用(Stm32 W5500 library file on the transplant, has been tested available)
STM32F103ZET6+6050dmp滤波+oled显示
- IIC oled显示mpu6050经DMP滤波后的数据，附带显示MCU的核心温度(IIC OLED shows the data of mpu6050 filtered by DMP, and the core temperature of MCU is attached)
6050
- 直接通过DMP获取姿态角度，无需利用卡尔曼滤波(MPU6050 K60 DMP this code is useful for the freshman to learn K60 about MPU6050 .)
LCD_线性CCD_无线传输
- 这是飞思卡尔智能车摄像头的线性CCD的程序(K60 for IAR, it is convenient for freshman to make smart car. To stdudy more knowledge.)
电磁感应模块_ADC_虚拟示波器_多功能调试上位机
- 这是飞思卡尔智能车的AD采集，通过虚拟示波器观看的数值的程序(IAR for K60. this code is for get AD by .. ,this convenient for freshman.)
user_code
- STM32F103单片机程序，使用了其3组串口，对数据进行处理转发(STM32F103 microcontroller program, using its 3 serial ports, the data processing, forwarding)
火灾报警程序
- 当火灾发生时，检测漏电电流，当电流大于保护设定的整定值时，驱动断路器分断电源(When a fire occurs, the leakage current is detected, and when the current is greater than the setting value of the protection setting, the circuit breaker is driven to break the power supply)
孵化环境温湿度监控系统设计
- 基于单片机编程实现孵化环境温湿度系统设计(Design of temperature and humidity system of incubation environment based on single chip microcomputer programming)
ok_w5500_转串口_无操作系统
- 以太网转串口,STM32+W5500,无操作系统移植(KEIL MDK+STM32+W5500,NO RTOS)