资源列表
VGA
- 基于VHDL语言的VGA显示控制程序，可以在1440x900分辨率的显示器上显示-Based on VHDL VGA display control program in 1440x900 resolution display on the monitor
three-value
- 三个数值的交换，输入三个数值，使输出数值不同。-Three values of the exchange, enter the three values , the output value of different
lcd.ucf
- the lcd ucf file in xilinx ise
and_gate
- verilog code for and gate
verilog
- 基于FPGA的LCD12864驱动显示程序 verilog hdl编译已通过 -LCD12864 Show verilog hdl compiler
img0430
- PCI接口图像存放地址分配程序,通过ＣＰＬＤ控制传入存储器-the address allocation of imagination storage by PCI port
led_key_beep
- 输入四路独立按键，输出四路独立LED和一个蜂鸣器。按下按键，对应的LED变量，同时蜂鸣器响，松开按键，对应的LED灭，蜂鸣器不响。蜂鸣器的功能是用四输入与门完成。这个四路很重要，整个电路扩展性很好。-Independent keys of the input four output four separate LED and a buzzer. Key is pressed, the corresponding LED variable, while the buzzer sounds, rel
msg_decode
- 对接收到的消息进行解码，通知消息处理模块进行消息处-Decode received the message, a notification message processing module messages at the
RTL
- 频率检测模块，停止检测可设10K~100K，低频检测1M，高频检测5M。用于7816通讯模块-Frequency detection module, the stop detection can be set to 10K to 100K, low-frequency detection 1M, high-frequency detection 5M. For 7816 communication module
uart_8
- 用verilog描述的串口通信接口，主体为接收机和发送机两个模块-Serial communication interface with Verilog descr iption, subject to a receiver and transmitter module two
add_64
- 64位verilog加法器，希望对大家有帮助
fpu_32bit
- to implement single precision arithmetic