资源列表
DE2_TV
- 这样的设计将DVD视频转换成合适的格式显示在CRT/ LCD显示器。应连接一个DVD视频源，如DVD播放器，在DE2开发板上的VIDEO IN端口。应连接一个CRT/ LCD显示器的VGA端口。应在DVD视频显示在监视器上。-This design converts DVD video into a format suitable for display on a CRT/LCD monitor. A DVD video source, such as a DVD player, should
ask
- sopc 按键中断，从0到9变化，程序简介明了！欢迎大家下载分享！-Sopc key interrupt, from 0 to 9 change, program introduction and sweet! Welcome everyone to download share!
DE2_i2sound
- 这种设计将来自麦克风的音频输入信号线相结合，并把结果输出到输出信号线。将麦克风连接到MIC端口，一个音频源的LINE IN端口，扬声器/耳机的LINE OUT端口。-This design combines audio input from the microphone and line in signals and outputs the result to the line out signal. Connect a microphone to the MIC port, an audio
51_eth_tx_rx
- 51单片机与以太网控制器的设计，实现数据于主机和PHY的封包解包与传输-51 MCU and the design of Ethernet controller, data from the host and the PHY packet unpacking and transmission
FINAL-371
- A four digits calculator programmed in Verilog. Can perform four basics arithmetics calculation of two digits numbers. Completely compatible to 4x4 matrix keyboard.
bl-8-gai-add24
- 迸发长度为8的DDR控制器，实现数据的读写，使用赛灵思的V2板子就行验证-Burst length 8 DDR controller, read and write data, and on line verification using Xilinx V2 board
i2c
- 用verilog写的I2C读写代码，用拨码开关输入数据，按键写入和读出，在LED数码管上显示。-I2C read and write code written in verilog DIP switch input data, key writing and reading, LED digital tube display.
CRC_for_8023
- 基于802.3以太网协议的CRC校验程序，使用VHDL语言，4位数据并行执行-CRC inspection program based on the 802.3 Ethernet protocol, the use of VHDL, four data parallel execution
FPGA-_control_DM9000A-Ethernet
- FPGA控制网口芯片DM9000A进行以太网传输数据。-The FPGA control network port chip the DM9000A Ethernet transmission data.
vhdl
- starter-3E板载vga端口驱动，并显示800*640的图像-Using PICOBLAZE to control the VGA Display on the Spartan-3E Starter Board
ts1
- TigerSharc TS201总线接口逻辑-TigerSharc TS201 bus interface logic
anjianliushuideng
- 按键流水灯程序 cpld语言 程序包括源程序和图还有所建立的项目-Button light water program