about draw.exe (source file draw7.f)

11/12/2005

---------------------------------------------------------------------

作用：

读入m12,m13,e11等程序的网格数据，输出.eps格式的图片

(Windows下免费的.eps文件查看软件 http://www.cs.wisc.edu/~ghost/)



用法：

1.程序运行时，首先出现提示

“TYPE THE INPUT FILENAME:”

这时直接输入m12,m13,e11等的数据文件



2.“SELECT MESHLINE MODE(0=NONE,1=COMPLEX,2=SIMPLE,3=CUSTOM)”

可以控制网格线的疏密，custom为自定义，若输入3，出现提示

“INPUT A NUMBER N (EVERY N LINES WILL OUTPUT ONE):”

每N条网格线中输出1条



3.“DRAW BORDER OR AXIS(0=NEITHER,1=BORDER,2=AXIS,3=BOTH):”

选择是否输出“坐标轴”和“边框”



扩展：

可以通过drawcfg.ini文件对输出图片进行适当的设置

当drawcfg.ini不存在时，程序采用默认值



其他：

1.由于做了某些假定，在特定情况下，程序可能不能正常运行

2.程序编写符合Fortran 77标准，可在window、linux、dos下编译运行-about draw.exe (source file draw7.f) 11 / 1 2 / 2005 ---------------------------------- ----------------------------------- role : Reading into the m12, m13, e11 procedures in grid data output. eps format photographs (Windows free. eps documents View software http : / / www.cs.wisc.edu/ ~ ghost /) Usage : 1. running, First prompted by the "TYPE THE INPUT FILENAME :" At this time the direct importation of m12. m13. e11 the two data files. "SELECT MESHLINE MODE (0 = NONE. COMPLEX = 1, 2 = SIMPLE, 3 = CUSTOM) "can control the grid spacing, Since the definition of custom, if the importation of three, prompted "INPUT A NUMBER N (N LINES WILL EVERY OUTPUT ONE) : "Each of the N grid line output a three." DRAW BORDER OR AXIS (0 = NEITHE R, a = BORDER, AXIS = 2, 3