资源列表
led blink using pic18f
- led blink using pic18f66k22
rx62n linker setup
- rx62n linker setup file
IAPWr
- philips单片机IAP写功能源代码,可以进行C语言链接-philips Singlechip IAP function of the source code to write, you can link to C language
dbgu.c
- Nand flash access debugger
touch
- 本实验是一个触摸屏实验，实验者触摸实验板的LCD屏幕，将从串口打印出当前点的坐标值。实验中需要定义触摸屏相关的数据结构TS_EVENT，数据结构TS_EVENT的内容包括按下触摸屏时的压力，位置。 实验环境： 创维特CVTs3c2410开发板 Redhat9.0-This experiment is a touch-screen experiment, the experimenter touch panel LCD screen test, print out the serial
1alljia
- 只要或上有事件发生，门实例语句即被执行。只要或上有事件发生，就执行语句，并且只要或上有事件发生，就执行连续赋值语句。
pwm
- 89C51单片机用定时器来产生ＰＷＭ方波，方波的频率与占空比可调
main
- TI公司的ZigBee模块 cc2530单片机带屏基础实验---LCD-test-TI ZigBee module CC2530 chip with screen based experiment--- LCD-test
interruput
- 利用定时/计数器T0从P1.0输出周期为1s的方波，让发光二极管以1HZ闪烁，设晶振频率为12MHz。 使用的是T0口在1方式下工作的-Use timing counter T0 from P1.0 output/1s of square wave period, let light emitting diode to 1HZ flashing, set crystal frequency for 12MHz. Use is T0 mouth in 1 mode
testeLCD
- código para dysplay LCD 4Bits no ATMEGA328
MtoNgencount
- Consider a counter that counts from m to n and then wraps around. Derive HDL code for the counter. Use generics, M and N, for m and n of the counter.(Note: there should be one control as UP/DOWN such that when UP/DOWN=1 then counts UP and for 0 it co
ex1
- PC104总线，使接在PB口上的4个绿灯亮，4个红灯灭-PC104 bus, so connected to the PB port 4 green light, red light off 4