资源列表
led
- 该程序是用Verilog编写的关于led的硬件电路描述程序，运用该程序可以对其进行仿真及测试。-The program is written in Verilog hardware circuit descr iption of the procedures led the use of the program can be simulated and tested.
signal_generator
- 如何产生一个正弦信号发生器，设计方案，原理图-How to generate a sinusoidal signal generator, design, schematic
uart-TO-SPI-FLASH-20130226
- 代码实现了电脑向uart 发送四个字节（命令1字节 地址3字节）然后 对M25Pxx系列的芯片进行任意地址的读写， 目前只实现单字节默认数据的读写！有需要的可以 修改-uart to spi control the M25PXX IC
vhdl_sw_lr
- 我自己写的vhdl程序，内有画图器，ram 和控制ram。还有test bentch。-I wrote it myself vhdl procedures, which are drawing device, and control of ram ram. There bentch test.
Verilog-UART
- 功能：UART串口通讯实信实验 描述：本程序共四个模块 模块1：接收数据的波特率发生模块，接收模块在接收到下降沿时，通过标志位启 动该模块的波特率计数器，并在计数中返回一个采样标志位给接受模块， 通知接收模块采样； ---------------------------------------------------------------------- 模块2：数据接收模块，该模块一旦监测到数据输入端有下降沿，就立即启动波 特率（标志位置1），并使
Avalon_VGA
- Avalon_VGA，-- This design provides an interface to the Alcahest VGA daughter card. -- The design comprises of an 8-bit VGA driver with Avalon bus interfaces. There are a total of -- three Avalon interfaces.-Avalon_VGA. -- This design provides an
labd3_adc
- PIC ADC LCD converter
cycloneiii
- cycloneiii引脚分配图 excel版本-cycloneiii pin assignment plan excel version of the
sram
- 用FPGA 控制sram读写程序的小程序，-fpga control precedure
I2C-peizhi
- 利用i2c配置adv7180 将模拟信号转成数字信号bt656-i2c configuration adv7180
SPI-Verilog-123
- spi slave code s pi slave code spi slave code -spi slave code spi slave code spi slave code spi slave code
NCO
- 查表法实现NCO数控振荡器，16位频率控制字深度1024，包含ROM表-nco rom