资源列表
project2
- 基于FPGA实验板设计一个远程控制系统，接收由计算机发出的数据，和实验板上矩阵键盘输入的数据完成相应的运算之后，结果显示在实验板的数码管上，同时发送回计算机显示。(A remote control system is designed based on the experimental board of FPGA, which receives the data sent by the computer and completes the corresponding calculation wi
基于fpga的简单cpu
- 可实现多位16位16进制加减，8位乘除，算数逻辑移位等功能的cpu
Custom-IP-to-a-hardware-design
- EXCD-1 可编程片上系统 实验例程 EDK部分 功能：定制一个IP 到硬件设计-EXCD-1 programmable system on chip test routines EDK some of the features: a custom IP to hardware design
nios2ex1
- 很好的一个verilog 历程,适合初学者,很有帮助-a good case
sdram_demo
- 主要编写了sdram的驱动程序开发程序，在开发板上运行成功-this file is to drive sdr sdram , it runs on platform successfully
xilinx_p
- fpga开发板程序，非常适合初学及中级开发者，全部程序经过测试-fpga development board procedures, is very suitable for beginners and intermediate developers, the entire program has been tested
decoder3_8
- 带有一开一关功能的38译码器,已测试验证可用(an decoder 3 to 8 with switch)
Computer-Architecture-lab6
- 计算机组成实验作业6，fpga开发板，verilog语言编写-Composition of experimental computer operating 6, fpga development board, verilog language
VHDL101
- A part of VHDL design book
452CLK
- 一个关于 ch452的一个FPGA源程序，很犀利~-A source on ch452 an FPGA, very sharp ~
chapter4_fsk_2
- 2FSK调制模块，包括了仿真文件.当输入为1时，输出载波1，当输入为0时，输出载波2-2FSK modulation module, including a simulation file when input is 1, the output carrier 1, when the input is 0, the output carrier 2
aurora_8b10b_v5_2
- xilinx xupv5-110t sma口（aurora）调试 ，LVDS-xilinx xupv5-110t aurora