资源列表
hanshuxinhaogai.rar
- 用FPGA做的DDS函数信号发生器，希望大家喜欢,FPGA to do with the DDS Function Generator, I hope everyone likes
lcd
- fpga开发板实现lcd1602显示屏显示数字时钟。开发板测试通过-FPGA development board to achieve LCD1602 display digital clock. Through the development board test
myFPGA
- FPGA芯片测量两路信号的相位差，将相差信号以脉冲数的形式发出-FPGA measure the difference between two signals’signal
7
- fpga paper for research
mmk_CD_v1.4
- FPGA Demos for MAX II: (1) Traffice Lights Control (2) LED Control (3) Switch Control (4) Control Pannel
singleandmulti_cic
- CIC滤波器的fpga实现 实现语言是vhdl 里面包括两个工程分别是单级cic 和多级cic-cicfilter fpga sigcic mulcic
Virtex2_Manual
- Xilinx is disclosing this user guide, manual, release note, and/or specification (the "Documentation") to you solely for use in the development of designs to operate with Xilinx hardware devices. You may not reproduce, distribute, republish, downlo
HDMI_ADV7511
- HDMI芯片ADV7511资料介绍，其中AN1270里面有一套DEMO源码，可以显示。-The information on the chip ADV7511 HDMI, which AN1270 document DEMO inside source confirmed with the DEMO display.
13-45
- 本程序能够完成的功能是，自动或手动测温，读取配置寄存器，温度下限寄存器，温度上限寄存器，设定温度上限及下限，当温度到达预定的温度的时候报警。所有的读取操作都可以在数码管上显示。其中，温度的上限通过计算机用串口通信协议传输给FPGA内部寄存器然后按动开关写入。同时，本程序还驱动了一个直流电机，温度高的时候电机转速高，温度低的时候转速降低直至停转。数码管可以实时显示电机转速，2秒刷新一次。数码管的显示可以在显示的温度、寄存器值和直流电机转速间切换，切换通过串口进行，计算机发00H时切换到温度及寄存器
FIFO
- Designed Fifo 16bit Designed Fifo 16bit Designed Fifo 16bit-Designed Fifo 16bit Designed Fifo 16bit Designed Fifo 16bit Designed Fifo 16bit
USB2.0
- usb2.0 fpga程序 用vhdl语言编写 quartus环境实现 -usb2.0 fpga using vhdl language program quartus environment to achieve
StateCad
- StateCAD独立运行版，不需要ISE-StateCAD stand-alone version, without ISE