资源列表
Integrator
- libero环境下利用verilogHDL实现积分器功能-libero environment using an integrating function verilogHDL
Differentiators
- libero环境下利用verilogHDL实现微分器功能-libero environment using verilogHDL achieve differentiator function
UART_D
- 这是一个串口调试程序，实现了数据传输判断，通过串口调试助手调试成功-This is a serial debugger, to achieve a data transfer judgments, through the serial debugging assistant debugging success
sn74181
- 运算alu的设计,并附上运算器的代码检测，简单的描述运算器的作用-Computing alu design
ex3
- FPGA控制的电机驱动VHDL代码，可实现正转，反转，启动，停止。并可以实现PWM调速。代码中预留了控制接口，可方便完成上述功能的实现。- The code is for driver based on FPGA. It can realize the function of start, stop, speed adjust.
ex1
- 设计一个循环灯控制器，该控制器控制红、绿、黄三个发光管循环发亮。要求红发光管亮2秒，绿发光管亮3秒，黄发光管亮1秒。（假设外部提供频率为1MHz的方波信号） 编程环境为Quartus II 11.0 仿真环境为 Modelsim 6.6d 通过仿真可以看出。系统复位后，红发光管亮2秒，绿发光管亮3秒，黄发光管亮1秒，三个发光管循环发亮。 -Design a loop lamp controller that controls the red, green and ye
ex2
- 驱动四位共阴极数码管数字显示的电路如图所示。该电路采用动态扫描显示技术，当扫描信号的频率大于50Hz时，可显示稳定的四位数码。试采用FPGA器件设计该电路。写出每个模块的VHDL程序；并在相应的EDA仿真工具上进行仿真。-Drive four common cathode LED digital display circuit as shown. This circuit uses dynamic scanning display technology, when the scan signal
Oscilloscope
- 开发板上芯片是cycloneII，利用Verilog HDL语言编写程序，将波形和波形数据显示在2.4寸TFT液晶屏上。在开发板上成功实现。-Development board chip is cycloneII, use of Verilog HDL language programming, the waveform and waveform data is shown in 2.4-inch TFT LCD screen. Successful implementation of the
26879085sttc4
- Package is for developing the g Encoding techniques and developed in the MATLAB
TMS dsp430 src (FMF)
- FMF model, using with standart FPGA toolset
register file generation
- the zip file consist of the verilog code which generate the 32 bit reg file so that u can read and write the data into them
uart protocol transmission
- todays data trans mission consist of more secured and low power with redused cost in technique well for that here is universel asyncronous reciever and transmitter with some protocol which make it to be secured