资源列表
GBJC
- 平坦度检测中的高度检测算法，使用ISE开发环境，语言为VHDL，平台是XC3S4-a vhdl_program used for flat detect
Center
- 使用Xilinx3S400开发的钢板检测算法中心化算法，通过测试。-a vhdl-program use Xilinx3S400
crc
- VHDL cyclic redundancy check generator und receiver
edh_ed_handbook
- Altera® provides various tools for development of hardware and software for embedded systems. This handbook complements the primary documentation for these tools by describing how to most effectively use the tools. It recommends design styles and
tut_embedded_programming_verilog_C_DE2
- This tutorial explains how to communicate with IO devices on the DE2 Board and how to deal with interrupts using C and the Altera Monitor Program. Two example programs are given that diplay the state of the toggle switches on the red LEDs. The ᤙ
tut_nios2_introduction
- This tutorial presents an introduction to Altera’s Nios R II processor, which is a soft processor that can be in- stantiated on an Altera FPGA device. It describes the basic architecture of Nios II and its instruction set. The NiosII processor a
tut_debug_software_verilogDE2
- This tutorial presents some basic concepts that can be helpful in debugging of application programs written in the Nios II assembly language, which run on Altera’s DE2 boards.
tut_DE2_sdram_vhdl
- This tutorial explains how the SDRAM chip on ltera’s DE2 Development and Education board can be used with a Nios II system implemented by using the Altera SOPC Builder.
myled
- 利用if语句实现流水灯设计。工具：Quartus ii 6.0 语言：VHDL-If statement using lights to achieve the design flow. Tools: Quartus ii 6.0 Language: VHDL
myclk
- 两位独立数码管100进制计数器，每1秒计数一次。从0到99，到99后又回到0.-Two independent 100-band digital tube counters, every time 1 seconds count. From 0 to 99, to 99 and then back to 0.
myf_adder
- 用例化语句和case语句编写的全加器的VHDL描述。-Of statements were prepared using the full adder of the VHDL descr iption.
myled4
- 四位动态数码管显示数字时钟的分位和秒位。工具：Quartus ii 6.0 语言：VHDL-4 shows the number of dynamic digital tube digital clock and seconds bit. Tools: Quartus ii 6.0 Language: VHDL