资源列表
04_LCD1602_Display_Design
- LCD1602的verilog驱动源码，有需要的拿去用-lcd1602 source code
fsmc_fpga
- STM32单片机与FPGA 总线通信源码，编译通过，有需要的拿去用-stm32 fpga fsmc source code
qiduanxianshi
- Verilog代码段,包括七段数码管显示电路，调试通过的代码哦，很实用-Verilog code segments, including the seven-segment LED display circuit, code debugging through, oh, very practical
sht30
- 温湿度传感器sht30驱动，系统时钟为125M可读出温湿度。-sht30 driver,sysclk=125MHZ
bouncing_ball
- vga输出跳动小球代码，采用vhdl编码，通用各种fpga期间-vga outputs bouncing ball
beep
- beep蜂鸣器输出报警声实验 滴。。滴。。滴。。 -beep buzzer alarm sound experiment
bram_shift_reg_w16x3072
- 使用 xilinx blockram 做连续shift 在图像处理中 做多行缓存很方便-Using blockram Xilinx as a continuous shift in the image processing to do more than the cache is convenient
Clk50M_div_1HZ
- 分频实验，将50M时钟分频为1HZ，输出LED1，闪亮-Crossover experiments, 50M clock divider is 1HZ, output LED1, shiny
key_led
- 读取按键信号实验 如果按下的是key1,那么点亮LED1 如果按下的是key2,那么点亮LED1-LED2 以此类推，如果下按key8，那么全部点亮8个led-Reads the key signal experiment If you press the key1, then lit LED1 If you press the key2, then lit LED1-LED2 So, if the next press key8, then all eight led
dled
- 通过程序编写实现动态数码管显示实验，挨个显示1，2，3，4，5，6，7，8-Dynamic digital tube display through programming experiments, one by one show 1,2,3,4,5,6,7,8
ckey_led
- 拨码开关驱动控制LED 如果拨码开关推上去1,那么点亮LED1 如果拨码开关推上去2,那么点亮LED2-DIP switch drive control LED If the DIP switch is pushed up one, then lit LED1 If the DIP switch is pushed up to 2, then lit LED2
risc16f84_latest.tar
- iT IS A 16 bit RISC processor,,It is easily virtualizable and reconfigurable.It is implemented in FPGA.