资源列表
E_RS232
- RS232编码的串行通信，可以调整波特率-RS232 coding of serial communication, can adjust the baud rate...
Multi11Mulply
- 本程序是11位带符号位的乘法器，其中最高位为符号位(sign)，中间7位是指数部分(Exponent)，最后3位是尾数(Matissa)。表示数据的范围是-2^-63-----+2^64.该工程文件有完整的程序，以及波形,验证正确。-This procedure is the unsigned 11-bit multiplier, one of the highest for the sign bit (sign), are between 7 part Index (Exponent), th
digital_7
- Verilog七段数码管显示控制程序，已经在实验板上测试通过。-Verilog seven-segment LED display control program, the board has been tested in the experiment.
Synchronous-multiplexer
- 四路复接器设计，调用分频器，时序发生器，译码器，内码器等实现-The Design of Synchronous multiplexer Based on FPGA
rom
- 基于verilog的rom存储器 简单实用 初学者的好材料-Rom memory, based on simple and practical verilog' s good material for beginners
ShiftReg
- 算术移位寄存器和逻辑移位寄存器的简单设计，内附详细説明。-Arithmetic shift register and logic shift register of simple design, containing a detailed descr iption.
FIR_lowpass
- 在FPGA上实现一个FIR滤波器，适当修改滤波器参数，就可以运用于自己的工程中-In the FPGA to achieve a FIR filter, appropriate changes to filter parameters, you can apply your own project
LED
- 按下列顺序无限循环移动彩灯显示电路，LED灯总数为8个，具体循环次序如下：1.D7,D3,其余灭，右移三次后全灭 2。D4,D0亮，其余灭，左移三次后全灭 3。D3,D4亮，其余灭，各向两边移三次后全灭 4，D7,D0亮，其余灭，各向中间移三次后全灭 -----上述灯移动的间隔为0.5s-In the following order infinite loop mobile lantern display circuit, LED lights total of 8, th
apbi2c-master
- apb转i2c verilog 实现(APB bus interface to I2C bus interface)
taxi_THE-FINAL
- 基于FPGA的汽车计费系统，根据不同的情况会有不同的计费方式，基本能够符合实际情况-FPGA-based auto billing system, depending on the situation will be different billing methods, and can basically meet the actual situation
count
- 基于FPGA的可变模的计数器，计数器，加法-FPGA-based variable modulus counter, counter, addition
DM2_KX8051_FTEST_RS232_C5T
- 这是一个FPGA的简单例程，主要是基于FPGA的232串口通信的例程-This is a simple routine FPGA is mainly based on FPGA-232 serial communication routines