资源列表
vivado2016.2-license
- Vivado Design Suite v2016.2版本license-the license of Vivado Design Suite v2016.2
keyscanverilog
- verilog语言，在按键按下或者是释放的 时候都会出现一个不稳定的抖动时间，如果不处理好这个抖动时间，我们就无法处理好按键 编码，所以我们的设计中必须有效消除按键抖动。 -In the button is pressed or released When there will be an unstable time jitter, jitter if you do not handle this time, we can not deal with the key Codi
mux16
- 该程序中中就是要利用时序逻辑设计方法来设计一个 16 位乘法器-The program is to take advantage of the sequential logic design method to design a 16-bit multiplier
svpwm
- 永磁同步电机的SVPWM，电机的PWM波的产生程序，-Permanent magnet synchronous motor SVPWM, motor PWM wave generation program,
SATA3.0
- SATA3.0协议详细说明，PS：全英文介绍！-SATA3.0 Procotol
SATA_Procotol_Summary
- SATA存储技术介绍文档，含协议及应用说明-SATA Technology
SATA_IP_FPGA
- SATA协议简要分析及其FPGA实现说明- SATA1.0 IP based on Fpga
IIR
- 基于nios ii嵌入式系统的IIR滤波器实现，自带ADC,DAC驱动代码-according nios ii
h_adder
- 基于两个半加器和一个异或门组成的全加器（资料中波形图为半加器的时序仿真图）-Based on two half-adder and an exclusive-or gate full adder (profile picture shows a half adder waveform timing simulation diagram)
7-BCD
- 7段数码管控制接口程序和对初始频率为50MHZ的时钟的分频程序-7-segment control interface program and the initial frequency of 50MHZ clock divider program
uart
- 一种串行uart接口的实现，可支持对种通信速率，modlesim仿真-Realizing serial uart interface, which can support a variety of communication speed, modlesim simulation
QAM_FPGA
- QAM调制，基于FPGA的实现，包含有乘法器模块、升降余弦滤波器模块、QAM序列生成模块-QAM modulator,the implementation based on FPGA,include MUL、FIRCOS and QAM generate