资源列表
DOC-JTag-cable-drawing
- XILNX 的 JTAG 燒錄線內部電路圖. 已經驗証過可行, 配合 XILNX ISE 可直接對 FPGA 編程.-It s the circuit diagram of the XILNX JTAG programming cable. It was approved OK. Can drectly programming the FPGA via ISE platform.
cable
- Schematic Diagram of XILINX III downloader cable
xilinx_cable
- xilinx下载电缆原理图，用于自制下载电缆-xilinx download cable schematic
led-shangshuo
- 单片机控制LED闪烁，时钟频率为8MHz高频与32KHz下，可切换。-Single-chip control LED flash, the clock frequency of 8MHz high frequency 32KHz, switchable.
dds
- 用VHDL在quartarsII下编写的DDS程序代码-In quartarsII with VHDL code, prepared DDS
pingpongqiu
- DE2-70上运行的小程序，已经经过验证：画面中有16个小球，小球碰到屏幕边缘就会向相反方向运动。程序可综合，直接下载到板子即可。-DE2-70 running on a small program, has been proven: 16 small ball, small ball hit the edge of the screen will be moving in the opposite direction in the picture. The program can be int
huffman
- 基于fpga的霍夫曼编码Huffman Encoder-Fpga-based Huffman coding Huffman Encoder
3-8-encoder-design
- 通过应用QUARTUSII开发软件对3—8译码器进行设计，给出运行程序和结果-Development through the application of QUARTUSII 3-8 decoder software for design, operational procedures and results are given
Traffic-lights-program
- 设计一个交通信号灯控制电路。要求： 1、主干道和支干道交替放行，主干道每次放行30秒，支干道每次放行20秒。 2、每次绿灯变红灯时，黄灯先亮5秒钟，此时原红灯不变。 3、用十进制数字（递增计数）显示放行和等待时间。-The design of a traffic signal control circuits. Requirements: 1, main roads and branch roads alternately release, the main road each re
TLV5618
- TLV5618可编程双路12位数模转换器产生三角波正弦波-The TLV5618 Programmable Dual 12-bit DAC and the triangle sine wave
mips_cpu_code_Rev_0.5
- vhdl MIPS CODE , WORKING GOOD
ldpc-for-fpga-decoding
- ldpc译码算法的matlab实现，码长960，码率1/2,完全模拟fpga硬件实现语言，量化处理。-ldpc decoding using matalb,code length 960,code rate 1/2