资源列表
sdram_led1
- 用于焊接硬件ＳＤＲＡＭ时调试，FPGA驱动SDRAM看能否工作，led可选用户自定义引脚-Used in the welding of the hardware SDRAM, FPGA driver SDRAM to see whether the work, led optional user defined pin
addersub4
- 用拨码开关输入两个四位二进制数，按下运算按钮后，以 led 的方式显示运算的结果。拓展 1 ．在基本功能实现前提下，增加一个清零功能。 2 ．更换显示方式，结果用数码管进行显示。 3 ．对溢出值的考虑。如果发生溢出现象，则数码管显示“ E ”。 -Use DIP switches to enter two four binary numbers, press the operation button to display the results led the operation
ADS523x
- ADI 高速ADC芯片ADS523x 的Avalon IP核-the ADI high speed ADC chip ADS523x s Avalon IP core
ahb_slave
- 主要是用来描述的ahb slave的文件-ahb slave file
ahb_master
- ahb master 文件，主要是ahb发数据-ahb master file
ahb_decode
- ahb decoder 文件，主要描述ahbdecoder-ahb decoder file
ahb_arb_def
- ahb arbiterdefine 文件-ahb arbiterdefine
led_test
- 开发板上，用来点亮led灯并且通过按键使灯的亮灭变化的Verilog源码-Development board for lit by led lights and buttons to change the bright lights Verilog source
Communication
- TMS320F28335与CPLD通讯，scib-TMS320F28335 and CPLD communication
Test
- sprtan6 xc6slx45+tms320f28335
232control429
- 通过串口发送不同的帧命令控制FPGA分别发送和接收429信号。-Send and receive 429 signals through the serial port to send different frame command control FPGA.
232controlrecieve
- 通过串口发送帧命令控制FPGA接收429板卡发送的信号，并点亮相应LED。-Through the serial port to send the command to send the FPGA to receive the 429 card board to send the signal, and light up the corresponding LED.