资源列表
demo5-charlcd1
- 字符液晶实验,字符液晶上进行显示字符。字符液晶实验,字符液晶上进行显示字符。-Character LCD experiment, character LCD display character. Character LCD experiment, character LCD display character.
an499_design_example
- cpld 控制 8-32M sdram 控制器 maxII epm570实现。
MAXII-Evalboard-V1.00-Designpa
- 完整的ALTERA MAXⅡEPM570试验板资料，包括原理图和PCB图，BOM表，可以直接做板。,Complete ALTERA MAX Ⅱ EPM570 test boards, including schematic and PCB diagram, BOM tables, plates can be directly done.
PS2_ctrl
- （1）对输入的时钟进行分频，得到190Hz 和25Hz 时钟信号，提供给其它模块作为时 钟输入； （2）键盘扫描模块：接收键盘的输入PS2C 和PS2D，并得到键盘扫描码xkey(15:0)； （3）数码管显示电路：将键盘扫描模块输出的扫描码显示在七段数码管。-(1) the input clock frequency division, get 190Hz and 25Hz clock signal, provided to other modules as the time
FPGAshiyan(10)
- FPGA入门系列实验教程——实验十数码管静态显示-FPGA tutorial series of experiments started- ten digital static display experiment
PWM
- PWM信号产生代码
UART
- verilog写的串口程序，其功能完全最正确，带工程文件-verilog to write the serial program, its function is completely the right, with the project file
adder1
- 3位二进制运算及数码管扫描显示电路，其中采用原理图描述方式-3 binary arithmetic and digital display circuit
test_parallel_dds
- 提供了DDS模块板的演示程序。该程序能够使模块输出频率为156.25KHz的正弦波。-The control signals of the chip are asserted by the FPGA chip on the // core board completely. If the FPGA chip is configured properly and // there is no wrong connection, you can see a sine wave
I2Ctvp5150
- I2C配置tvp5150用VHDL写的 -I2C configuration tvp5150 written using VHDL
DDR2_ctrl
- DDR2 SDRAM控制器的设计及FPGA验证
write1
- 串行接口发送，通过绑定DE2上的拨码开关，然后通过RS232接口传送到pc上，可通过串口调试大师接收数据-Serial interface to send, through binding DE2 DIP switch, and then transmitted via the RS232 interface to the pc, can receive data through the serial debug master